Publicité
Les langues disponibles
Les langues disponibles
9. Do not transport, carry or hang the pump by its cable, use the carrying handle.
10. DANGER! Electric Shock!
Moisture can penetrate into the electrical part of the power cord through a cut plug, and cause a short
circuit.
Never cut the plug (eg. For electrical installation through a wall).
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected from its power
source.
4.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damage
WARNING!
- The warranty does not cover accidents due to improper installation. This pump must be installed in
accordance with local standards and by a qualified person (we recommend you to contact an electrician).
- The fixed pipeline that will connect the pump must include a separation device having contacts with the
opening distance of at least 3 mm in all poles.
- The total head must not exceed 40 m.
4.3- Electrical connection
IMPORTANT! If the power cable is damaged, it must be replaced by the manufacturer, its after sales
service or a person with similar qualification in order to avoid any danger.
a) Make sure that the power supply corresponds with the connection specifications of the device (see
rating label).
b) Check that the power cable is not damaged.
2
3×1.0mm
(or exceed 1mm
c) Connect plug to a wall socket 10/16A fitted with a ground connection.
d) Turn the pump for 2 to 3 seconds to perform a dry run of the pump.
Do not operate the pump without water for more than 2 to 3 seconds to avoid overheating. This will cause
permanent damage.
e) Disconnect the pump from the power supply (remove the plug from the wall socket), and then proceed
with delivery/discharge line connection, as described in the following paragraph.
f) Ensure that the electrical connection is protected against water splashing.
g) When operating outdoors, the electrical connections must be splash-proof; they must not lie in water.
h) Extension cords must have sufficient wire cross section; cable drums must be complete unwound.
4.3- Connecting the discharge line (not supplied)
a) Wedge the discharge hose (not supplied) on to the connector.
b) Add a fixing collar (hose clamp not supplied) to complete the seal.
The cable must be at least one cable H07 RN8-F
2
) (line, neutral and earth).
Page 15 / 26
Publicité
