Smeg BCC01 Manuel De L'utilisateur page 25

CLEANING AND MAINTENANCE
(Fig. C-E-G-H-I-L)
Manual rinse
• Make sure that the Primary program is
selected with keys (16), (17), (18), (19)
illuminated in white.
• With the machine ready to dispense and
the drip tray mounted, press the keys (20)
and (19)
least 3 seconds: the machine will rinse the
coffee circuit (coffee dispenser 11).
• At the end of the washing cycle, the keys
light up steadily.
Cleaning of the machine body
For a good preservation of the external
surfaces it is necessary to clean them regularly
at the end of each use, after letting them cool.
Clean with a soft cloth dampened with water.
Never immerse the machine body
(1) in water or other liquids.
Allow the machine to cool down
before cleaning.
Cleaning the external drip tray (14)
The drip tray (14) is equipped with a red
float (27) which protrudes from the cup-holder
grid as soon as the maximum liquid level is
exceeded.
• Remove the tray (14) and the cup-holder
grid (28) and empty it.
• Clean the tray (14) and the grid (28) in
running water with neutral dish detergent.
• Dry the components and reassemble them
in the machine.
EN - 8
Cleaning and maintenance
simultaneously for at
C l e a n i n g t h e c o f f e e g ro u n d s
container (12) and internal tray (13)
Always empty the coffee grounds
container with the appliance
switched on. This is the only way
of resetting the coffee grounds
counter.
• Remove the tray (14).
• Remove the grounds container (12) with its
tray (13) by pulling it outwards.
• Empty the coffee grounds from the container
(12).
• Clean the container (12) and the tray (13)
in running water with neutral dish detergent.
• Dry the components and reassemble them
in the machine.
Daily cleaning of the coffee grounds
container and internal tray is
recommended.
Cleaning the water tank (5)
• Remove the lid (4) and remove the tank (5)
from the machine using the appropriate
handle.
• Clean the tank (5) in running water with
neutral dish detergent and reassemble it in
the machine.
Cleaning the brewing group (15)
Before performing this cleaning
operation, ALWAYS disconnect the
plug from the power outlet.
• Press the door (8) in the lower part until it
releases then remove it from the upper part.
• Press the two release clips (29) located on
the sides of the infuser (15) and remove it
from the machine
• Wash the brew group (15) with running
water, dry it and reassemble it in the
machine, making sure it is positioned
(Fig.L).