Hach PHOSPHAX sigma Manuel D'utilisation De Base page 132

Software menu system
PHOSPHAX sigma
mg/ l P
12,0
14:01:20
04.11.12
100
80
60
40
20
00
00 00 00 00 00
4 6 8 10 12 14
100%
8:00 14.07
10
1.9 mg/l P
1 Graphic keys
3 Arrow keys
5 Intersection data point
7 Y key/Y axis
Phosphax Σ sigma menu overview
SETTINGS Setting of all device parameters: This includes measurement range, correction factor, current output, date, time etc.
INPUT SIGNALS Device-internal measurement data
OUTPUT TEST Check of all connected data lines
SERVICE Maintenance- and repair work
STATUS Error description and acknowledgement
CURVE Presetting of the measurement data graphic
MODBUS Setting of the MODBUS parameters
SETTINGS ADJ. CONTRAST (display readability)
English 132
Menue Grafik
F1 Y
F2
M
O
X
F3 Z O
F4
Menue Grafik
Y
F1
Y
F2
M
O
X
F3 Z O
F4
2 Curve diagram
4 Cursor
6 X key/X axis
Graphic functions
When you press one of the four graphic keys for 3 seconds, the display switches to the graphic
mode with curve diagram. Via the now active graphic keys a whole series of different displays can
be shown on the display.
Operate graphic keys
The two large arrow keys below move the cursor on the curve. The data of the intersection
point of the cursor/curve can be found underneath the diagram shown.
With the two X and Y keys, you change the scale of the corresponding axes:
Axis scale
X axis (time axis): 12 h, 24 h, 48 h, 7 days, 28 days
Y axis (measurement value axis in %): dependent on the cursor/curve intersection point
5 %, 10 %, 50 %, 100 % around this intersection point
Note: 100 % = set measurement range for the current output,
menu item [CURRENT RANGE 0..]