Publicité
Les langues disponibles
Les langues disponibles
MOULF145-NoticeEPC_NC00011921:Mise en page 1
• Do not open the lid until the float is down.
• Do not place any foreign objects on the
top of the pressure limit valve. Do not
replace the valve.
• Do not use a cloth between the lid and the
housing to leave it ajar.
• Keep the bottom of the inner pot and the
heating plate clean.
• Do not heat up the inner pot in other
thermal energy nor replace it with another
pot.
• Use a wooden or plastic spoon to prevent
any damage to the coating of the inner
pot.
• During cooking & steam release, the
appliance expresses heat and steam.
Keep your face and hands away for the
steam flow. Do not touch the lid during
- fig. 24.
cooking
• If a great deal of steam is released from
the rim of the lid, unplug the power cord at
once, and send the appliance to our
service center to repair.
TROUBLESHOOTING
TROUBLE
The appliance beeps and the
.
display shows
The appliance automatically
switches to Keep Warm
without going through a
complete cooking cycle
Lid will not lock
Cannot open the lid after
steam released
Air escape from the rim of the
lid
Steam is released from the
float valve
The float cannot rise
13/05/09
• If the alarm is on for more than 1 minute,
please do not use the appliance.
• When transporting the appliance, always
use the carry handles and not the knob on
the lid.
• You must not take the appliance apart or
replace any components.
• Do not replace the power cord with other
cords.
• Keep out of the reach of children.
• Do not use the cooking pot on other
stovetops or in other appliances.
• If pressure is released continuously (during more
than 1 minute) while pressure cooking, send the
appliance to a service center for repair.
• Do not fill up the Minut' Cook without the
cooking pot.
• When opening the lid, always hold the lid
by its knob. In some cases, boiling water
may be trapped between the gasket
supporting cover and the lid. This can
cause severe scalding.
POSSIBLE REASONS
• The appliance is unable to
build up pressure
• When there is not enough
water in the cooking pot, the
appliance will go into safety
mode
• The sealing gasket is not
installed properly
• The float stays up
• The float is still up
• No sealing gasket
• Food stuck in sealing gasket
• Sealing gasket needs to be
replaced
• Lid not locked properly
• Food stuck in the sealing
gasket of the float valve
• The sealing gasket on the float
is too old
• The pressure limit valve is not
placed properly
• Not enough food and water
• Steam is released from the rim
of the lid and the pressure limit
valve
10:58
Page 9
TREATMENT
• Check that the lid is closed
properly and that the valve is in
- fig. 11
the correct position
• Add more water in the cooking
pot and restart the cooking cycle
• Replace the sealing gasket in
position
• If this occurs just after cooking,
remove the valve. Then close the lid
and place the valve back into
position. If the product has not been
used and is cold, push the push rod
in directly with your hands
• Press the float down with
chopsticks
• Install the sealing gasket
• Clean the sealing gasket
• Replace the sealing gasket
• Lock the lid again
• Clean the sealing gasket
• Replace the sealing gasket
• Change the sealing gasket every
two years
• Place the device to
• Put more food and
water in the inner pot
• Send the product to our service
center for repair
GB
FR
AR
FA
9
Publicité
