Replacing The Feeder And Separator Roller - Panini Vision X Mode D'emploi

5.5 Replacing the Feeder and Separator Roller

After extended use it will be necessary to replace the Feeder and Separator Roller rings due to normal wear.
1. Open the inner and outer covers.
2. Carefully lift the rings off the rollers.
Feeder ring
3. Install the new separator rings on the hubs by pressing down on
the surface of the rings, making sure the rings are installed flat on
their seats. The feeder ring must be rolled onto the black pulley.
OPERATOR MANUAL
Front separator ring
Page 35
Rear separator ring
Maintenance