Cleaning The Transport - Panini Vision X Mode D'emploi

5.1 Cleaning the Transport

Dust, lint and small particles can get into the track area. Clean this area as follows:
1. Remove the inner and outer covers by
pulling up on the covers.
2. To remove the U-track, pull back on lever (A)
away from unit.
3. Inspect and clean the entire track area from beginning to end.
4. Remove staples, paper clips, rubber bands, and pieces of paper that may have accumulated during use.
5. Using a container of canned air and nozzle, spray the track area and check entrance.
OPERATOR MANUAL Page 30 Maintenance