Technaxx TX-29 Manuel D'utilisation page 77

Settings  Device manage:
Add
Quick setup
Add area
Add device
Modify device
Clear devices
Flush
Assign IP
Settings  Device settings:
Device
information
General setting
Network setting
Encoding setting Set main and sub stream settings like encode mode, encoding format,
Record settings
Screen settings
PTZ settings
Video detection
settings
Alarm settings
Channel mode
setting
Settings  Local settings:
General settings Set language, import or export setting information, automatically
Record settings
Storage settings
By checking the box in front of one or more devices from the device list
and then pressing Add the selected devices will be add to a Area.
All devices in the device list will be added
Add areas for organizing the cameras.
Add a device manually by filling in all needed information.
Edit the device settings.
All devices are deleted from the area.
Refresh device list.
Edit IP address.
By clicking on a device from the device list you get several
information's about the device. Note: Information of the device is only
available from added devices. Click on the device from the list.
Set date format, HDD overwrite or dwell interval for full screen or
screen divided.
Set DHCP on/ off, set the port, see P2P ID and set PPPoE on or off.
quality, bit and frame rate.
Set the record plan for every channel, select Timing, Motion or/and
Sensor (see chapter 5.3 record setup  record plan).
Set the channel name of the channel.
Set different options for the PTZ.
Set the sensitivity, duration, alarm and buzzer for motion detect and
video loss (see chapter 5.3 channel setup  video detection).
Set alarm, buzzer, work mode and alarm duration.
Set the amount of analogue and digital channel the NVR should
support.
synchronize time and connect devices on start up.
Set the record plan for every channel, select Timing or/and motion (see
chapter 5.3 record setup  record plan).
Set the local disk letter, HDD overwrite and HDD reserved.
31