Technaxx TX-29 Manuel D'utilisation page 57

Security premium caméra ensemble
Masquer les pouces Voir aussi pour TX-29:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Advanced
Added devices:
Delete
Delete All
Manual Edit
Channel Setup
WiFi Setup
Repeater: Repeater function is for extending the range of the WiFi signal of the NVR. The
camera that is set as repeater has to be in the range of the NVR (open field 40m). The
camera that you will connect to the repeater camera should be in the range of 30m (open
field) to the repeater camera. Follow the steps below to install. Attention!: Don't forget,
cameras that are connected by repeater function get all turned off when the first repeater is
disconnected from the power supply.
Multiply Network Segment
(not supported)
Allow Repeated Add
Intelligent Add
Select a camera from the added device list and delete it!
Delete all cameras in the added device list!
Edit channel connection parameters. You can flip the image 180° with
Image Rollover.
Press the button, then you get to main Channel Setup page. Here you
can change the Channel & Encode mode.
Press the button, then you get to main WiFi Setup page. Here you can
change or edit the SSID for better WiFi connection. Attention: If you
change SSID or Password you have to reconnect the cameras. See
chapter 4.4.
Multiply Network Segment means that
access a segment to add the device.
When enabled you can add the same
camera more than one time
Intelligent
functionality. It is mainly used for the
wired camera. You can ignore it. The
intelligent add will check if the IP
camera and the NVR segment are the
same. If not, the NVR will change the
IP camera segment to be the same as
the NVR automatically.
11
add
is
smart
add

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tx-30

Table des Matières