Manual Record; Volume; Setup Wizard; Fast Network - Technaxx TX-29 Manuel D'utilisation

5.8 Manual record

Open the menu by clicking the mouse right button on the main interface  Manual record.
To manually record the wanted channel you have to check the box of the channel and click
on OK. See picture below. It is also possible to select "All" or "All on" than will all channels
be recorded. By pressing "All off" the manual record will be stopped.

5.9 Volume

Set the system volume here. It defines the volume of the buzzer. (Buzzer volume can also
be defined by pressing the  key for decreasing and the  key for increasing of the
monitor.)

5.10 Setup Wizard

Here you can see the Device ID as QR code. By checking the box below you can start the
Boot Wizard again. This helps you setting the basic options of the TX-29/TX-30

5.11 Fast network

Here you can see the Device ID as QR code. You can setup the network options of the
TX-29/TX-30 with two options. Choose Auto Config to let the NVR set everything on his one
or choose Manual Config to set IP, Gateway and subnet mask by yourself. Under Manual
Config you can also decide to choose the PPPoE function if necessary for you. Click on
Apply or OK to save the settings. By clicking on the button Diagnose the NVR will scan his
network connection and tell you the status in the line Network Status.

5.12 Add Camera

By entering this option the NVR will start searching and adding cameras nearby. It's a fast
adding function. It will stop when you click on Exit. After that you can see the automatically
added cameras on the display.

5.13 Exit System

Under Exit System you can Logout the current user, Reboot the device, close the screen
output (to reactivate the display, double click the left mouse button) and Shutdown the
system.
22