Sensorless Dc Control Pairing Procedures - Kichler 65 GENTRY Manuel D'instructions

SENSORLESS DC CONTROL PAIRING PROCEDURES

IMPORTANT: Ceiling fan blades MUST be installed before pairing procedure can begin.
Step 1. Program the wall control and/or the handset control separately. Once the following pairing is successfully done, both the
wall control and the handset control can be used for the fan.
For wall control,
fan branch circuit at the circuit breaker or fuse box. Within 60 seconds of turning on the power, press the " " power button to
turn on the wall control (the button will be down), and then press the " " reverse button for 3 to 5 seconds. Light will blink twice.
The remote will now be programmed to your fan and ready for use.
For handset control, restore electricity to the ceiling fan branch circuit at the circuit breaker or fuse box. Within 60 seconds of
turning on the power, press " " power button for 3 to 5 seconds. Light will blink twice. The remote will now be programmed to
your fan and ready for use.
IMPORTANT: Do not interrupt the conditioning until the fan comes to a complete stop in approximately 5 minutes. All functions of
the control will be rejected during conditioning.
If
programming is unsuccessful, retry the process starting from step 1 again.
18 | KICHLER.COM