Publicité
Example for Bit programming:
a loco shall run in reverse direction with user-programmed speed steps, analog operation shall be possible:
Bit 1 = 1, Bit 2 = 0, Bit 3 = 4, Bit 4 = 0, Bit 5 = 16, Bit 6 = 0. 1+4+16=21.
Thus, program CV 29 to function value 21.
When programming with newer 55015P Universal Remotes ("parallel" with "C" programming mode) or
55045 MTS PC Decoder Programming Modules, all function values are programmed directly.
Programming procedure with older 55015 Universal Remotes ("P" programming mode):
- Registers CV1 through CV4 can be programmed directly by programming the desired
function value in the register.
- To program higher CVs:
- In register CV6, input the number of the register you want to program.
- Then input the desired function value in register CV5.
Example:
Set hand-over function to ON (program register CV54 to function value 3).
To program:
- Display shows "P --"
- Select register CV6 (press 6).
- Input 54 (register you want to program).
- Execute programming (press right arrow button).
- Display shows "P --"
- Select register CV5 (press 5).
- Input 3 (selected function value)
- Execute programming (press right arrow button).
33
Publicité
