Publicité
Les langues disponibles
Les langues disponibles
7.1.1 Cutting
▶ When cutting, apply moderate feed pressure and do not tilt the product
or the cutting disc to either side (hold at approx. 90° to the cutting plane).
For best results when cutting profiles and small-section rectangular
tubes, start cutting at the smallest cross section.
7.1.2 Rough grinding
▶ Move the product to and fro while maintaining a 5° to 30° angle of attack
and applying moderate pressure.
➥ This will avoid overheating and discoloration of the workpiece and help
ensure an even surface finish.
7.2 Switching on and off
7.2.1 Switching on
1. Plug the supply cord into the power outlet.
2. Press the rear section of the on/off switch.
3. Slide the on/off switch forward.
4. Lock the on/off switch.
➥ The motor runs.
7.2.2 Switching off
▶ Press the rear section of the on/off switch.
➥ The on/off switch jumps into the off position and the motor stops.
8
Care of the product
DANGER
Electric shock due to breakdown of protective insulation. When working
on metal under extreme conditions, conductive dust may accumulate inside
the power tool, thereby adversely affecting the protective insulation.
▶ Use a stationary dust extraction system when working under extreme
conditions.
▶ Clean the air vents frequently.
▶ Use a ground fault circuit interrupter (GFCI) in the electric power supply
line to the power tool.
WARNING
Electrical hazards. Improper repairs to electrical parts may lead to serious
injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Never operate the product when the air vents are blocked. Clean the air
vents carefully using a dry brush. Do not allow foreign objects to enter the
interior of the product.
18
English
Printed: 19.10.2018 | Doc-Nr: PUB / 5402266 / 000 / 01
2141935
*2141935*
Publicité
