Publicité
Les langues disponibles
Les langues disponibles
4. Use an open-end wrench to tighten the accessory tool securely and then
release the spindle lockbutton.
6.4.6 Removing a threaded accessory tool
1. Disconnect the mains plug from the power outlet.
CAUTION
Risk of breakage and irreparable damage. If the spindle lockbutton is
pressed while the spindle is rotating, the accessory tool can detach from the
power tool.
▶ Press the spindle lockbutton only when the spindle has stopped rotating.
2. Press the spindle lockbutton and hold it in this position.
3. Use an open-end wrench to release the accessory tool.
4. Release the spindle lockbutton and remove the accessory tool.
6.5 Fitting the wire brush
1. Disconnect the mains plug from the power outlet.
2. Fit the side handle. → page 14
3. Install the guard. → page 14
4. Place the wire brush in position and tighten it hand-tight.
5. Press the spindle lockbutton and hold it in this position.
6. Tighten the wire brush with a suitable open-end wrench.
7. Then release the spindle lockbutton and remove the open-end wrench.
6.6 Fitting the abrasive resin-fiber disc
1. Disconnect the mains plug from the power outlet.
2. Fit the side handle. → page 14
3. Install the guard. → page 14
4. Fit the support plate and the abrasive resin-fiber disc, screw on the
clamping nut and tighten it securely.
5. Press the spindle lockbutton and hold it in this position.
6. Use the pin wrench to tighten the clamping nut securely, then release the
spindle lockbutton and remove the wrench.
7
Operation
7.1 Grinding
CAUTION
Risk of injury. The accessory tool may suddenly stick or stall.
▶ Use the power tool with the side handle (or optional hoop grip) fitted and
always hold the power tool securely with both hands.
*2141935*
Printed: 19.10.2018 | Doc-Nr: PUB / 5402266 / 000 / 01
11
2141935
12
English
17
Publicité
