Bosch BLAZE GLM 42 Consignes De Sécurité/D'utilisation page 21

highlighted square appears over the indicator for indi-
rect height
pear in the status bar. Press the measure button 2 [ ]
to select indirect height measurement.
0.0º
The measuring values for the distance A and the angle
C at which you took the measurement will display in
the measured-value lines c.
b. Double indirect height measurement
(see figure C on page 5)
The laser measure can measure a vertical distance on
a surface, by taking two indirect measurements to that
surface.
Press the function button 7 [Func] and use the plus
button 3 [ ] or minus button 8 [ ] to cycle through the
measurement functions until the highlighted square
appears over the indicator for indirect measurement
Press the measure button 2 [ ]. Press the plus but-
ton 3 [ ] or minus button 8 [ ] to cycle through the
indirect measurement functions until the highlighted
square appears over the indicator for double indirect
height
the status bar. Press the measure button 2 [ ] to se-
lect double indirect height measurement.
0.0º
2610051599 03-18 GLM42.indd 21
and the words "Indirect Height" ap-
Press the measure button 2 [ ] to ac-
tivate the laser. Tilt the laser measure
while keeping the base of the laser
38'01"
⅝
measure stable and point the laser at
45.0°
the height of the object you wish to
measure. Press the measure button
2 [ ] to take your measurement.
5'05" ⅓
The desired indirect height measure-
ment X will display in the result line d.
and the word "Indirect" appears in the status bar.
and the words "Double Height" appear in
Press the measure button 2 [ ] to ac-
tivate the laser. Make sure the measur-
ing reference point remains stable.
4'02"
⁄
Press the measure button 2 [ ] to
8'05"
take the first measurement A. Press
45.0° the measure button 2 [ ] to take the
second measurement B.
6'02" ⁄
-21-
3/23/18 9:52 AM