Bosch BLAZE GLM 42 Consignes De Sécurité/D'utilisation page 14

Assembly
Inserting/Replacing the Batteries
Using alkali-manganese or rechargeable batteries is
recommended for operation of the measuring tool.
With 1.2V rechargeable batteries fewer measurements
could be possible than with 1.5V batteries.
To open the battery lid 9, press the latch 10 and re-
move the battery lid. Insert the batteries. When insert-
ing, pay attention to the correct polarity according to
the representation on the inside of the battery com-
partment.
When the empty battery symbol first appears on the
display, then approximately 100 measurements are
still possible. When the battery symbol is empty and
red flashing, measurements are no longer possible.
Replace the batteries.
Always replace all batteries at the same time. Only
use batteries from one brand and with identical ca-
pacity.
Remove the batteries from the laser measure when
not using it for extended periods. When storing for
extended periods, the batteries can corrode and dis-
charge themselves.
-14-
2610051599 03-18 GLM42.indd 14 3/23/18 9:52 AM