Bosch BLAZE GLM 42 Consignes De Sécurité/D'utilisation page 24

Note: With a length measurement, the end result is
display immediately.
To exit addition, press button 7 [Func].
Subtracting Values
To subtract values, press button 8 [ ]. The subse-
quent steps are the same as for "Adding Values".
Deleting Measured Values
Briefly pressing the On/Off button 5 [ ] will delete
the last measured value in all measuring functions. Re-
peated brief pressing of the On/Off button 5 [ ] will
delete the measured values in reverse order.
Target Card
The target card 18 is designed to use your laser mea-
sure where there is no surface to point the laser at
(e.g. the end of a table). Remove the protective cover
from the bottom of the target card. Attach the adhe-
sive portion of the target card to the object you wish
to measure (e.g. the edge of the table). You now have
a surface (target) to point the laser at and get your
measurement.
-24-
2610051599 03-18 GLM42.indd 24 3/23/18 9:52 AM