Personal Safety - Expondo Stamos S-DIGITRON 200P Manuel D'utilisation

6. When operating a power tool outside, sue an outdoor extension
cord marker "W- A" or "W". These extension cords are rated for outdoor
use, and reduce the risk of electric shock.

Personal Safety

1. Stay alert. Watch what you are doing, and use common sense
when operating a power tool. Do not use a power tool while tired
or under the influence of drugs, alcohol, or medication. A moment of
inattention while operating power tools may result in serious personal injury.
2. Dress properly. Do not wear loose clothing or jewelry. Contain
long hair. Keep your hair, clothing, and gloves away from moving
parts. Loose clothes, jewelry, or long hair can be caught in moving parts.
3. Avoid accidental staring. Be sure the Power Switch is off before
plugging in. Carrying power tools with your finger on the Power Switch, or plug-
ging in power tools with the Power Switch on, invites accidents.
4. Remove adjusting keys or wrenches before turning the power tool
on. A wrench or a key that is left attached to a rotating part of the power tool may
result in personal injury.
5. Do not overreach. Keep proper footing and balance at all times.
Proper footing and balance enables better control of the power tool in unexpected
situations.
6. Use safety equipment. Always wear eye protection. Dust mask,
non-skid safety shoes, hard hat, or hearing protection must be used for appropriate
conditions.
Tool Use and Care
1. Use clamps (not included) or other practical ways to secure and
support the workpiece to a stable platform. Holding the work piece by
hand ro against your body is unstable and may lead to loss of control.
2. Do not force the tool. Use the correct tool for your application.
The correct tool will do the job better and safer at the rate for which it is designed.
3. Do not use the power tool if the Power Switch does not turn it on
or off. Any tool that cannot be controlled with the Power Switch is dangerous and
must be replaced.
EN
Rev. 02.03.2017
40
40
4. Disconnect the Power Cord Plug from the power source before
making any adjustments, changing accessories, or storing the tool.
Such preventive safety measures reduce the risk of starting the tool accidentally.
5. Store idle tools out of reach of children and other untrained per-
sons. Tools are dangerous in the hands of untrained users.
6. Maintain tools with care. Keep cutting tools maintained and clean.
Properly maintained tools are less likely to bind and are easier to control. Do not use
a damaged tool. Tag damaged tools "Do not use" until repaired
7. Check for misalignment or binding of moving parts, breakage of
parts, and any other condition that may affect the tool's operation.
If damaged, have the tool serviced before using. Many accidents are
caused by poorly maintained tools.
8. Use only accessories that are recommended by the manufacturer
for your model. Accessories that may be suitable for one tool may become hazar-
dous when used on another tool.
Service
1. Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
2. When servicing a tool, use only identical replacement parts. Use of unauthorized
parts or failure to follow maintenance instructions may create a risk of electric
shock or injury.
SPECIFIC SAFETY RULES
1. Maintain labels and nameplates on the tool. These carry important
information. If unreadable or missing, contact our service team for a replacement.
2. Always wear the approved safety impact eye goggles and heavy
work gloves when suing the tool.
3. Maintain a safe working environment. Keep the work area well lit. Make
sure there is adequate surrounding workspace. Always keep the work area free
of obstructions, grease, oil, trash, and other debris. Do not use a power tool in areas
near flammable chemicals, dusts, and vapors. Do not use this product in a
damp or wet location.
Rev. 02.03.2017
EN
41