afx light FAZE700 Manuel D'utilisation page 9

the PCB, and have it brushed clean both sides with dilute alcohol. Leave it dry itself, then install
it back. Make sure all wires are well connected.
• Clean the metal cover with dry cloth.
IMPORTANT NOTE
Before you switch off the machine, stop all fogging and wait 30 seconds until the cleaning proce-
dure is finished. Only then switch the unit off. This is too avoid that liquid stays in the pipe and
starts fogging when you switch the machine on next time.
APPENDIX A: WIRED CONTROLLER
The DJ DMX Faze Machine is designed with volume adjustable controller. Detail operation as bel-
lows;
1. Firmly attach the remote control to socket (Figure1-K) on the back of the FAZE700. The red LED
(power) on the remote control will light up;
2. The LED display of FAZE700 shows P.xxx , fogging controlled by display stops working, puff vo-
lume controlled by the remote control;
3. When FAZE700 reaches its operating temperature, the green LED of the remote control will light
up. You can control the fog emission with the rotating knob;
4. Rotate the knob clockwise to increase the smoke volume or counterclockwise to decrease the
smoke volume. If you rotate it completely coutnerclockwise, the smoke will stop. The LED display
of FAZE700 will show cLn_. meaning left liquid cleaning.
P. 0 means that cleaning is completed.
A: 1/4" jack
B: Adjustment knob
C: Green LED
D: Red LED (power)
www.afx-light.com
9 EN