Manual Operation - afx light FAZE700 Manuel D'utilisation

Machine à brouillard
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

d.xxx: Setting duration of timing fogging(Duration=3~250s). i.xxx: Setting interval of timing fog-
ging(Interval=5~250s).
UP: Button for increasing numerical value
DOWN: Button for decreasing numerical value
ENTER: Starting button of fogging, release to stop.
Please note:
• Self-cleaning function: The machine design of machine stops working after a delay of 30 se-
conds, automatically clear the tubing of the remaining liquid.
• Set values are automatically saved.
Important remarks:
To reduce the possibility of that the wind mouth gets humid, the software will detect the wind value
and the fog value, and do proper adjustment. Under display control mode (timing fogging, conti-
nuous fogging) or DMX control mode: when fog value is adjusted to 100%, the software will adjust
wind value (even it is set at 5%) to 30% automatically; when wind value is adjusted to 5%, the
software will reduce fog value to 50% automatically. This will prevent the smoke vent from getting
humid because of too small wind but too much fog. *Fog value = Puff Volume, wind value = Fan
OPERATION
• Plug mains power cord from the faze machine into an appropriate mains outlet.
Primary power on
1 second after, the current software version is displayed
2 seconds later, the unit switches into working status and is heating up.
• Wait about 75 seconds for the heating element to heat up.
When heating is completed, follow the different operating modes.

MANUAL OPERATION

When heating is completed, this message is displayed to show standby status.
• In this status, press ENTER to start fogging.
• In Fogging status, adjust puff volume and fan
Press UP or DOWN to adjust the puff volume (5-100%)
• Press MENU to switch into Fan adjustment.
Press UP or DOWN to adjust the fan (5-100%)
• In fogging status, press ENTER to stop fogging
Please note that the machine will stop automatically after a delay of 30 seconds to
clear the tubing of remaining liquid.
After cleaning, it goes back into standby status.
TIME-CONTROLLED FOGGING OPERATION
• Press MENU to switch the built-in timer ON/OFF..
or
• When the built-in timer is set to ON, press MENU to display duration and interval
EN
6
Press UP or DOWN to switch the time ON or OFF
© Copyright LOTRONIC 2019

Publicité

Table des Matières
loading

Table des Matières