La-Z-Boy Power Plus Mode D'emploi page 10

Power Sofa with Headrest
and Lumbar Assembly Instructions
4. Adjust the glides to ensure a height that provides a clear path for operation of the legrest. Each glide is
attached to the base rail by one jam nut and one lock washer on top of the base rail, and one jam nut
on the bottom of the base rail.
To extend the glide, loosen the upper jam nut by rotating clockwise. Turn the lower jam nut
•
clockwise to the desired height.
Tighten the upper jam nut by rotating counterclockwise.
•
Repeat steps one and two for each adjustable glide on the unit, if needed.
•
Repeat this procedure, as necessary, to adjust the front height of the unit and level it.
•
Upper Jam Nut
Lock
Washer
Base Rail
5. Locate the motor connector, one behind each reclining seat (F
motor connectors and to the power supply.
Align one motor connector to a long lead Y-cable connector, push the connectors together until
•
seated and close the locking cover to secure the connection (F
motor connector and Y-cable long lead. Then align the short lead of the Y-cable to the power supply
connector, push the connectors together until seated and close the locking cover to secure the
connection (F 8).
IGURE
6. Connect the 120 volt power cord to the power supply (F
the Operating Instructions.
7. Proceed to the Battery Backup Assembly Instructions.
To Remove a Back:
1. Unplug the 120 volt power cord and disconnect the power supply from the Y-cable. Reverse the
Assembly Instructions steps. When lifting the back up from the body, to lay across the arms,
make sure to do so slowly and carefully to prevent damage to the electrical connections.
2. Repeat step 1 for the other side of the back.
18
Lower Jam Nut
Adjustable Glide
6). Connect the Y-cable to the
IGURE
7). Repeat this for the other
IGURE
9). Do not plug in until instructed in
IGURE
Power Sofa with Headrest
and Lumbar Assembly Instructions
F 6
IGURE
Motor Connector
F 8
IGURE
Make this
connection
Y-Cable Short Lead Power Supply
F 7
IGURE
Make these
connections
Y-Cable Long Leads
F 9
IGURE
Make this
connection
Power Supply 120 Volt Power Cord
19