Faults/Troubleshooting; Overview - BADU OmniTronic Traduction Du Instruction D'utilisation Originale

Faults/troubleshooting

7 Faults/troubleshooting
7.1

Overview

Problem: Leak found in pipe to sewer (inspection glass on valve).
Possible causes
Impurities in valve (sand) or on
the seal.
Problem: The backwash/rinse cycle cannot be started via the
right-hand key on the display.
Possible causes
Key not pressed long enough.
Problem: Loud snapping noise in the drive housing
Solution
Find the cause and repair the fault.

 Replace the motor sprocket.
38 EN
Solution
 Backwash in order to
remove any dirt from the
seal.
 A function run can be
achieved by switching
on/off at the rocker switch.
 Send the actuator and
valve lid to the
manufacturer.
Solution
 Press the right-hand key
on the display for more
than 3 seconds.
04|2019