Nordcap ZANUSSI ZXSG Mode D'emploi page 21

ENGLISH
Anomaly
Smears or spots on the
glasses.
Low pressure from wash
arms.
Low pressure from rinse arms. Loss of
The dishwasher is switched
off, but the appliance contin-
ues to fill water.
Wash cycle indicator is off.
The wash pump does not
work.
The drain pump does not
work.
If the fault persists after carrying out the above checks,
contact the Customer Care Service, remembering to
specify:
A. the type of fault;
B. the appliance PNC (product number code);
C. the Ser. No. (appliance serial number).
20
Type of Possible causes
anomaly
Too much rinse-aid.
Loss of The tank filter is clogged.
performance
The wash pump filter is clogged.
The water drainage hose is
clogged.
The wash pump does not work
properly.
The rinse arms are clogged.
performance
The water pressure after pressure
reducer is less than 1 bar.
Loss of Inlet valve is damaged.
performance
The water in the wash tank does
Loss of
performance not reach the set temperature.
The water in the boiler does not
reach the set temperature.
Blocking The wash pump is clogged.
Loss of The drain pump is clogged.
performance
Actions
Reduce the amount of rinse-aid.
Call detergent and rinse aid service
centre.
Clean the tank filter.
Clean the wash pump filter.
Call service centre.
Call service centre.
Clean the rinse arms.
Call service centre.
Close the water supply tap or taps and
call service centre.
Call service centre.
Call service centre.
Call service centre.
Call service centre.
IMPORTANT
The appliance PNC and serial number are essential
for identifying the type of appliance and date of
manufacture.
NOTE!
For detailed information about the troubleshooting
see the complete user manual in the web site.