Using Your Stroller - Evenflo SmartFold Instructions D'assemblage Et D'utilisation

USING YOUR STROLLER

2
B
3
C
D
D
4
E
E
F
Continue to either Step 5A or Step 5B, depending on the model you own.
6
*
Some models feature swivel locks that improve handling over
rough ground.
To keep front wheels from swiveling, pull up on the swivel
lock levers B . Push down the swivel locks to restore the
swivel action.
To open the child's tray , pull a locking tab on either
C D
side of the tray.
Note: You can open the tray from either side .
C
To remove the tray C , pull
both tabs and remove the tray
from the stroller.
WARNING
To avoid serious injury, DO NOT raise or recline seat with
child in stroller .
To recline seat, press the strap release button on the
adjuster E and allow seat to recline.
To raise the seat, hold the D-ring , then press the
F
release button and slide the adjuster E toward the
seat.
5A
I
H
5-pt Harness
H Step 1
H
G G
K
Step 2
H
M
J
M
I
3-pt Harness
K
L
M
M
J
G
K
5B
5-pt Harness
Step 1
G
H
G
G
H I
I
Step 2
G
J L
H
L
3-pt Harness
I
K
L
L
J
USING YOUR STROLLER
WARNING
To avoid serious injury from falling or sliding out, ALWAYS use waist restraint .
Note: Verify the in-seat fold locks on both sides are locked by lifting up the
rear of the stroller using the parent's handle .
Lock the rear brakes and pivot the child's tray out of the way.
5-point Harness:
With the 5-point harness, the harness shoulder straps
at shoulder height or lower and use the harness strap buttonholes
closest to the baby's shoulders, as shown. To adjust the height of the
harness straps to the baby's shoulder height, do the following:
1. On the back of the stroller, insert each harness shoulder strap buckle
through the corresponding buttonhole in the seat back, as shown, and
H
push it through to the front side of the seat back.
2. On the front of the stroller, insert each harness shoulder strap buckle
from Step 1 through the corresponding buttonhole
I
desired height location in the seat back, as shown, and push it
through to the back side of the seat.
5-point and 3-point Harnesses:
Place the baby in the seat and bring the crotch panel
the child's legs. Fasten each buckle . For a snug, comfortable fit,
K
pull the shoulder straps G to tighten the shoulder restraint (shoulder
restraint only for 5-point harness) and pull the waist restraint straps
to tighten the waist restraint.
Note: To loosen the waist straps , push in the release button
M
buckle and pull .
Once the child is properly restrained, close and lock the child's tray.
sure the tray locks into position with audible clicks. Pull on the child's
tray to make sure it is locked into place.
To change from 5-point to 3-point harness:
Remove each harness shoulder strap from each buckle
G
shown. Remove both shoulder straps from the stroller seat back. Store
shoulder straps for future use.
WARNING
To avoid serious injury from falling or sliding out, ALWAYS use waist restraint .
Note: Verify the in-seat fold locks on both sides are locked by lifting up the
rear of the stroller using the parent's handle .
Lock the rear brakes and pivot the child's tray out of the way.
5-point Harness:
With the 5-point harness, the harness shoulder straps
G
der height or lower, as shown, and use the harness strap loops
the baby's shoulders. To adjust the height of the harness shoulder straps to the
baby's shoulder height, do the following:
1. Remove each harness shoulder strap from each buckle
G
2. Thread each harness shoulder strap under the harness strap loop
G
that is closest to the baby's shoulder.
3. Reattach each harness shoulder strap to each buckle
G
5-point and 3-point Harnesses:
Place the baby in the seat and bring the crotch panel
the child's legs. Fasten each buckle . For a snug, comfortable fit,
I
pull the shoulder straps G to tighten the shoulder restraint (shoulder
restraint only for 5-point harness) and pull the waist restraint straps
to tighten the waist restraint.
Note: To loosen the waist straps, push in the release button
and pull .
Once the child is properly restrained, close and lock the child's tray.
sure the tray locks into position with audible clicks. Pull on the child's
tray to make sure it is locked into place.
To change from 5-point to 3-point harness:
Remove each harness shoulder strap from each buckle
G
G must start
H
I
at the
H
up between
J
M
on the
L
Make
, as
K
must start at shoul-
H closest to
, as shown.
I
H
.
I
J up between
M
on the buckle
K
Make
, as shown above.
I
7