Using Your Stroller With An Infant Car Seat - Evenflo SmartFold Instructions D'assemblage Et D'utilisation

USING YOUR STROLLER
6
L
7
P
N
M
8
Pull canopy hoop L forward to extend canopy.
Push canopy toward parent's handle to close.
WARNING
Care must be taken when folding or unfolding stroller
to prevent finger injury in hinge areas .
To fold the stroller, lock the front swivel wheels, lock the rear
brakes, close the canopy, and remove your child.
For models with the seat fold lock , push the lock inward while
M
pulling upward on the in-seat fold strap N , then lock the fold
latch . For models without this feature, pull upward on the
O
in-seat fold strap N , then lock the fold latch O .
To unfold the stroller, unlock the fold latch O , then grab the
parent's handle and pull upward until you hear the stroller open
fully with an audible click.
Note: Verify the in-seat fold locks on both sides are locked by
P
lifting up the rear of the stroller using the parent's handle .
O
• Only use the Evenflo Embrace infant car seats with this stroller.
Other infant car seats or carriers are not designed to fit the stroller frame and may result in serious injury to your child if used
with this stroller .
• To assure safety for your baby, please refer to the manufacturer's instructions for the use of your infant car seat and keep all
instructions available for reference .
• DO NOT lift stroller by using the infant car seat handle when installed on stroller .
• If unable to securely attach infant car seat to child's tray to this stroller, remove the car seat and contact Evenflo ParentLink
at 1-800-233-5921 (USA), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).
• To avoid serious injury to the child, when an infant car seat is in the stroller, make sure the infant car seat is securely snapped
onto the child's tray and secured with car seat stabilizer .
• Some Embrace infant car seats have a blanket/boot option that must be removed for proper attachment to this stroller .
1. Fully recline the seat back (page 6).
2. Make sure the child's tray
3. The infant car seat
Lower the infant car seat down onto the child's tray
B
downward until you hear the lock snap into place.
4. Secure the front of the infant car seat
Lift the car seat stabilizer
5. Pull up on the car seat handle to test the lock.
A
To remove the infant car seat, disconnect the car seat
disengage the seat release handle on the back of the infant car seat.
C
• Make sure the infant car seat
• Make sure the infant car seat is securely locked onto the child's tray
secured with car seat stabilizer
• Pull up on the car seat to test that it is properly locked into place.

USING YOUR STROLLER WITH AN INFANT CAR SEAT

WARNING
is securely latched.
A
MUST be in the rear-facing position.
B
A
with the car seat stabilizer
B
C over the locking channel D
stabilizer
CHECKLIST FOR PROPER INSTALLATION
B is in the rear-facing position.
.
C
Embrace
D
C
and press
.
C
, as shown.
and
A and
9