Rear Panel - Tascam MX-8A Mode D'emploi

Rear panel

ANALOG input/output connectors
4
These are balanced Euroblock analog input/output connec-
tors. (HOT, COLD, GND from the left)
RS-232C connector
5
This is a 9-pin D-sub RS-232C control input/output connector.
Pin No. Signal
1
2 RD
3 TD
4
5 GND
6
7
8
9
NOTE
You cam download the TASCAM Mixer protocol for MX-8A
from the TEAC Global Site (http://teac-global.com/).
RS-485 connector
6
Use this to connect an external controller.
Use a cable that is category 5e or higher for connection.
Pin No. Signal
1 B
2 A
3
4 DC24V
5 GND
6
7
8 GND
9
ATTENTION
i The RS-485 connector is not an Ethernet (LAN) connector.
Never connect a cable that is connected to a network to this
unit. Connecting such a cable mistakenly could cause this unit
or another device connected to the cable to malfunction.
i Always turn the unit power off before connecting or discon-
necting a cable. Connecting and disconnecting while the
power is on could cause malfunction.
8
TASCAM MX-8A
NOTE
A cover is attached to the RS-485 connector to prevent acci-
dental insertion of an Ethernet LAN cable. Remove this cover
before use.
Ethernet connector
7
This is an Ethernet port. Use this to connect to a network and
control the unit externally.
NOTE
You can download the TASCAM Mixer protocol for MX-8A from
the TEAC Global Site (http://teac-global.com/).
Link status/activity indicator
8
Green indicates that a link is established between the devices.
Blinking indicates that signals are being transmitted between
the devices.
100Mbps link status indicator
9
Orange indicates that a 100Mbps Ethernet link has been es-
tablished.
Operation mode switches
0
Use these switches to change the operation mode of the unit.
See "Using the operation mode switches" on page 11.
AC IN connector
q
Plug the included power cord in here.