Before You Start; Inserting / Replacing The Battery - Parkside PDM 300 C3 Mode D'emploi Et Consignes De Sécurité

Masquer les pouces Voir aussi pour PDM 300 C3:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

PARKSIDE PDM 300 C3

6. Before you start

Remove the multimeter and the accessories from the packaging. Before first use,
remove the protective film from the display [1].
Check the multimeter and the accessories for damage. If the multimeter is
damaged, do not use it.

6.1 Inserting / replacing the battery

The multimeter is powered by a 9 V block battery. The procedure for inserting or
replacing the battery is as follows:
WARNING! Switch the multimeter off and remove all measurement
cables before opening it!
CAUTION! If the battery is empty, the
display [1]. The battery should be replaced as soon as possible to ensure
proper functioning.
• Use the screwdriver provided to undo the top screw on the back of the
multimeter and remove the battery compartment cover by pulling it upwards.
12 - English
symbol appears on the

Publicité

Table des Matières
loading

Table des Matières