Out Of Range Display; Dc Voltage Measurement; Ac Voltage Measurement - Parkside PDM 300 C3 Mode D'emploi Et Consignes De Sécurité

PARKSIDE PDM 300 C3
You can also switch the multimeter off directly by turning the range selector
switch [3] to the "OFF" position.

7.1 Out of range display

The multimeter has an out-of-range display. If a measured value exceeds the
range limit for the measurement range selected, "0L" is shown on the display [1].
If this happens, remove the measurement probes [6] from the object you are
measuring immediately.

7.2 DC voltage measurement

• Connect the black measurement cable to the COM connection [4] and the
red measurement cable to the
• Set the range selector switch [3] to the V
• Connect the measurement probes [6] to the object to be measured.
• The measured reading is now shown on the display [1]. If the measured
reading is negative, a minus sign is shown in front. If "OL" is flashing on the
display [1], AC voltage is being measured. Set the range selector switch [3]
to the V position.
~

7.3 AC voltage measurement

• Connect the black measurement cable to the COM connection [4] and the
red measurement cable to the
• Set the range selector switch [3] to the V
• Connect the measurement probes [6] to the object to be measured.
• The measured reading is now shown on the display [1].
14 - English
OUT INPUT connection [5].
position.
OUT INPUT connection [5].
position.
~