Klarfit 10006712 Mode D'emploi page 13

Step 2:
a: Connect Tension Control Cable (17) with the wire of Tension Controller (10), and then
connect the Sensor wire (16) to the Extension Sensor Wire (15). Note: With the tension
controller (10) turned to its lowest settinig.
b: Fasten the Handlebar Post (9) to the Main Frame(1), secure in place with Inner Hexagon
Bolt (13) and Arc Washers (14) which are pre-attached to the Main frame (1).
Note: Ensure that all bolts and washers are in place and partially threaded in before com-
pletely tightening the bolt.
13