Domo DO7087S Mode D'emploi page 43

www.domo-elektro.be
DO7087S
PARTS
1. Filling cap
7
5
2. Trigger for removing the
3
water tank
1
3. Handle
6
8
4. Water tank
2
9
5. Steam release button
6. Soleplate
10
7. Temperature dial
12
4
8. Temperature indicator
9. Iron
10. Thermal insulation pads
14
11
11. Steam generator
13
12. Control panel
13. Cord clamp
14. Descaling cartridge
Trigger
Grab the water tank by the handle and pull the trigger with 1 finger. You can now
remove the water tank from the generator.
Filling cap
Open the filling cap and use the opening to fill the water tank.
On/off button
Plug in the appliance and press the on/off button. The on/off indicator will light up and
the lowest steam level indicator will start blinking. The appliance is now switched on.
To turn the appliance off again, press the on/off button and hold. The indicators will
go out and the appliance is now switched off.
Setting the steam level
The two arrows can be used to set the steam level: low, medium or high. When a
certain level has been selected, the corresponding indicator will start blinking and will
light up continously after a short while. You can now produce steam and iron with
steam.
Temperature indicator
When the iron is heating up, the temperature indicator will be lit up. When the set
temperature has been reached, the light indicator will go out again. During ironing the
indicator will alternately light up and go out again, as the iron is being kept at the right
temperature.
43