Adaptation To Various Types Of Gas - Fulgor Milano QLH 906 G WK Installation-Emploi-Entretien

suitable size for the rated capacity with
a clearance distance which completely
disconnects the power line under
EN
overvoltage category III conditions,
consistently with the rules of installation
(the yellow/green earth wir must not
be interrupted). The plug or omnipolar
switch must be easily reached on the
installed equipment.
To avoid all risk, if the power cable
becomes damaged, it must only be
replaced by the manufacturer, by an
authorised service centre, or by a
qualified electrician.
1 - CABLE-CLAMP
2 - YELLOW / GREEN
Fig. 6
Adaptation to various types
of gas
(Fig. 7) Should the appliance be re-set
for a different type of gas than available,
proceed as follows:
• replace the injectors (Fig. 7) with the
corresponding type of gas to be used
(see table " Uses characteristics")
• to adjust to the minimum, use a
screwdriver on the screw placed on
the tap (Fig. 8) after turning the tap
to its minimum position. For LPG
(butane / propane) screw tight.
22