Fulgor Milano QLH 906 G WK Installation-Emploi-Entretien page 17

Important
• use of the appliance produces heat
and moisture in the room where it is
installed. Make sure the kitchen is
sufficiently ventilated; keep natural
ventilation holes open or install
mechanical ventilation devices (such
as a hood).
• Prolonged use of the appliance may
require additional ventilation, such as
opening a window.
• on floors with
protection do not keep the ignite
button pushed for more than 15
seconds. If the burner has not ignited
after 15 seconds, open the door of
the room and wait at least one minute
before making a further attempt.
• on floors without protection, should
the burner flame go out close the
corresponding gas cock and wait at
least on minute before making any
attempt to ignite it.
Electrical plates / Vitroceramic
heating element
(Fig. 2-2a-3). Rotate the knob towards
the position required for cooking
and bear in mind that the higher the
number, the higher the heat output.
See table "use of electrical plates"/
heatin elements vitroceramic. The pilot
light signals that the plate is "on".
Some types of pilot lights will
maintain some slight luminescence
even after disconnection. That is
quite normal.
N.B.: When using electrical plates/
heating elements vitroceramic, we
thermoelectric
17
recommend flat bottom recipients with
a diameter equal or slightly larger than
that of the plate itself.
• avoid liquid overflow. Therefore, after
boiling or heating liquids, reduce the
heat output;
• do not leave the electrical plates on
with empty pots and pans;
• when cooking is finished, rotate
the knob back into closing and/or
disconnected position.
In the event of even a slight fracture
on the cooking vitroceramic surface,
disconnect the electric power supply
immediately.
DO NOT STARE AT THE HALOGEN
LAMP.
GAS
fish
wok
fast
semifast
auxiliary *
*with reduction grid
EN
20x32
Ø 20-32
Ø 20-26
Ø 14-20
Ø 10-14
Fig. 1