Publicité
Les langues disponibles
Les langues disponibles
How to Replace the Vacuum Belt
CAUTION: Unplug the vacuum cleaner before
performing any of these steps.
How to Remove the Bottom Plate
1.
Place the vacuum cleaner in the low position.
Turn the vacuum over.
2.
Slide the clips toward each other (Fig. 1).
3.
Remove the bottom plate.
How to Replace the Belt
1.
Turn the unit over and remove the bottom plate
as described in the above section.
2.
Remove the belt guard (Fig. 2). Remove the agitator
by pulling it straight out (Fig. 3).
3.
Remove the belt from the agitator.
4.
Loop a new belt over the motor pulley (Fig. 4)
and over the end of the agitator.
5.
Stretch the belt over the agitator while inserting
it back into the nozzle housing.
6.
Reinsert the belt guard.
7.
Replace the bottom plate by hooking the front end
of the plate into the two ribs on the front end
of the nozzle housing. Press the bottom plate into
place and fasten it with the two screws.
NOTE: To ensure maximum cleaning efficiency, check the belt
regularly to ensure it is in good condition. Replace the belt
if it is stretched, cracked or if excessive slipping is occurring.
7
Publicité
