Publicité
Les langues disponibles
Les langues disponibles
How to Assemble and Operate the Vacuum
How to Attach the Handle to the Vacuum Cleaner
The vacuum cleaner and the handle are packed separately.
1.
After first removing the handle screw, insert handle
into the hole on top of the vacuum cleaner. Make sure
that the cord hook on the handle is positioned to the
back of the vacuum cleaner (Fig. 1).
2.
Line up the small hole on the handle with the small
hole on the vacuum cleaner and insert the screw.
Make sure the screw is tightened securely.
How to Attach the Cord Retainer to the Handle
1.
Pull apart the rounded end of the cord retainer to
open it up enough to fit around the vacuum handle
(Fig. 2).
2.
Attach the cord retainer around the vacuum handle
and slide it down to the top of the hose hanger (Fig. 3).
3.
Create a loop in the power cord and push it through
the slot and over the hook of the cord retainer (Fig. 4).
4.
Pull down on the power cord to remove any slack.
On/Off Switch (Fig. 5)
1.
To turn the vacuum on, push the switch located
on the dust compartment to the ( I ) position.
2.
To turn the vacuum off, push the switch located
on the dust compartment on the ( 0 ) position.
How to Change the Vacuum Bag
Always operate the vacuum cleaner with a vacuum bag installed.
How to Change the Vacuum Bag
1.
Unplug the vacuum cleaner. Remove the used bag from
the bag holder (Fig.1).
2.
Pull the bottom corners of the new vacuum bag (Fig. 2).
3.
Attach the new vacuum bag onto the bag holder (Fig. 3).
4.
To ensure proper cleaning and extended motor life,
make sure the secondary bag support is always in place.
5.
Reinsert the tab on the end of the bag compartment
cover into the groove on the bag compartment housing.
Press it into place and fasten the bag compartment
tightly (Fig. 4).
4
Publicité
