Hilti SB 4-A22 Mode D'emploi Original page 13

Status
2 LEDs light up.
1 LED lights up.
1 LED flashes.
1 LED flashes, the power tool is not in working or-
der.
4 LEDs flash, the power tool is not in working or-
der.
Battery charge state cannot be indicated while the control switch is pressed and for 5 seconds after
the control switch has been released. If the LEDs of the charge state indicator flash, follow the
instructions in the 'Troubleshooting' section.
3.6 Items supplied
Bandsaw, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
4.1 Bandsaw
Rated voltage
Ambient temperature
Weight in accordance with EPTA Procedure 01 including B22⁄8.0 battery
No-load speed
Max. cutting depth
Bandsaw blade (Length x width x thickness)
Operating temperature
Storage temperature range (without battery)
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the electric tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
*2145465*
Meaning
Charge state: 25 % to 50 %
Charge state: 10 % to 25 %
Charge state: < 10 %
The battery has overheated or is completely dis-
charged.
The power tool is overloaded or has overheated.
2145465
SB 4-A22
21.6 V
−17 ℃ ... 60 ℃
4.3 kg
167 m/min
63.5 mm
733 mm x 12.7 mm x
0.5 mm or 733 mm x
12.4 mm x 0.35 mm
−10 ℃ ... 50 ℃
−30 ℃ ... 70 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
English 7