Setting The Timer To Turn One Or More Cooking Zones Off65 - Caso Germany Master E4 Slide Mode D'emploi

When the time is set, the display shows the remaining time.
When the time is up, , an acoustic signal soundsv, the
display shows "- -" and the device, or the cooking zone
goes into standby mode.
If you simultaneously press the + and - buttons (2), the
timer is deleted and "0:00" is displayed.
Please note
The timer can only be set/changed as long as the power level
flashes.
15.4.8 Setting the timer to turn one or more cooking zones off
If the timer is set on one zone:
Select the desired cooking zone and set the appropriate
power level. Then press the timer button (8).
Use the + / - (2) to set the time in 1-minute intervals, or
when holding for a while in 10 – 30 min. Intervals (min up to
9 hours, 59..)
When the desired time is set, it blinks a short time in the
display. Once the information in the display stops flashing,
the countdown begins to run.
If you want to make a timer setting for one or more other
cooking zones, please proceed as described above: Select
the zone, first make a power stage and then set the desired
time.
All cooking zones for which the timer counts are marked
with a red dot.
The point of the zone flashes.for which the current
countdown time is currently displayed in the timer display.
If you want to check the countdown as another drive, select
the hob, and appropriately, the display shows the remaining
time. After a short time but the setting jumps back to the last
selected cooking zone, which is again marked by a blinking
dot.
When the set time has elapsed, an audible signal is sent
out and the device, or the corresponding hob goes into
standby mode.
caso Master E4 Slide 65