bort medical Air Walker lang Mode D'emploi page 8

EN
1
Open the circumferential Velcro fasteners and remove the front cover.
2
Open the black padding liner and place the foot and lower leg in the Walker. Pay attention to good
heel positioning. Then, the black padding liner is closed, pay attention it sitting crease-free.
3
Now, adapt the grey front cover by attaching it centrally to the black padding liner again using Velcro.
Close the three circumferential Velcro fasteners. Start with the fastener over the instep area and
finally the lower leg fastener. If necessary, re-tighten again.
4
Now, fill the integrated air chambers using the blue pumps at the side. The air chambers can
be filled individually. Start with the inner (medial) pump, then the outer (lateral) pump.
5
If you wish to reduce the air pressure, you can release air. For this, fold the grey protective cap next
to the pumps upwards and press the silver-coloured button.
Accessories available:
Ref. 100 370 Understocking
Ref. 100 380 Protective cover against wetness
Ref. 100 390 Protective cover for night-time
Ref. 990 175 Heel wedge set for Air Walker Achillo
Removal
If you wish to remove the Walker, fold the grey protective cap next to the pumps upwards and press the
silver-coloured button. Then, open the circumferential Velcro fasteners and remove the front cover. Finally,
open the black padding liner and remove your foot from the Walker.
Tip: Close the Velcro fastener in order to avoid early wear to the Velcro surface.
Material composition
Polyester (PES), polyurethane (PUR), polyamide (PA)
The sewn in textile label provides the precise material composition.
Cleaning information
Hand-washing
Do not clean chemically
Hand wash the shoe using lukewarm water and mild detergents.
08
Do not bleach Do not dry in a tumble dryer Do not iron