Safety Instructions Relating Specifically To The Equipment - MeisterCraft MSB 710 E Traduction Du Manuel D'utilisation Original

5452160-Schlagbohr-man 15.01.14 09:26 Seite 34
Use of these devices can reduce dust
related hazards.
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be
controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
34
and tool bits etc. in accordance
All manuals and user guides at all-guides.com
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
b To avoid hazards, damaged power leads
must be replaced by the manufacturer
or his customer service representative.
6 – Safety instructions
relating specifically to
the equipment
Always protect eyes and
ears.
• Before drilling into walls make sure
that you are not breaking into an
electricity, gas or water supply line.
Use a detector.
• Always unplug drill before changing
drill or bit.
• The chuck key should always be
stored in the key holder.
• To avoid injuries, securely attach the
workpiece (e.g. with vice or clamp).
• When drilling or driving screws: Do not
allow the motor to stall under the load.
• Wear ear defenders when using an
impact drill. The effects of noise may
lead to loss of hearing.