Safety Instructions Relating Specifically To The Equipment - MeisterCraft MSB 850 EB Traduction Du Manuel D'utilisation Original

5452310-Schlagbohr-man 17.01.14 11:43 Seite 33
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
Special safety notes:
• Safety notes for hammer drills
- Wear ear defenders when using
hammer drills. The effects of noise
can lead to loss of hearing.
- Use the additional handle supplied
with the device. If you lose control of
the machine, it may cause injuries.
• Additional safety notes for hammer
drills
- Only activate the drive switch when
the engine is at a standstill.
Switching with the machine running
may cause damage to the gears.
- Never use the hammer drill as a
screwdriver. The tightening and
loosening of screws, nuts and
similar objects using the hammer
drill is not permitted.
- Water must be kept away from parts
of the electrical tool and from
people in the work place.
- Before you make a setting, service
or do maintenance on the device,
ensure that the power cable is
unplugged (not connected to the
power source).
- The electrical capacity of your
extension cable should be at least
as powerful as the device.
- Check to make sure that the mains
power supply matches the
All manuals and user guides at all-guides.com
Servicing
a) Only have electric tools repaired by
6 – Safety instructions
• Wear goggles and ear defenders.
• Before you start to drill holes in a
• Only change a drill/chuck with the
• In order to prevent injuries, ensure
• Avoid the engine coming to a
• The machine may only be used for
• Whilst operating, always hold the
specifications on the type plate of
the device.
- Check walls and ceilings in order to
avoid damaging hidden cables.
- Never touch the external housing
directly after drilling. This becomes
very hot during drilling operation.
qualified specialists and only allow
original replacement parts to be
used. This ensures that the safety of
the electrical tool is maintained.
relating specifically to
the equipment
wall, use a cable/metal detector to
make sure you are not going to hit
power lines, gas or water pipes.
device unplugged (not connected to
the power supply)!
that the item to be processed is
secured (e.g. by clamping in a vice).
standstill when drilling under
pressure.
the purpose it was designed for.
machine with both hands and ensure
that you are standing firmly.
33