Russell Hobbs food Serie Mode D'emploi page 66

Read the instructions, keep them safe, pass them on if you pass the appliance on.
Remove all packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of a responsible adult. Use and
store the appliance out of reach of children.
2 Don't put the appliance in liquid, don't use it in a bathroom, near water, or outdoors.
3 Unplug the appliance before fitting or removing attachments.
5 Keep your hands away from the blades – they're sharp
6 Don't fill with anything hotter than you can comfortably handle (i.e. liquid temperature
below 40°C).
7 The appliance is fitted with a safety switch to prevent the motor operating unless the jug is in
place and the lid correctly fitted. Don't use this to switch the appliance on and off.
8 Don't leave the appliance unattended while plugged in.
9 Don't let the jug overflow. If liquid gets under the motor unit, it may be sucked into the motor,
damaging it.
10 Don't run the motor continuously for more than 5 minutes, it may overheat. After 5 minutes
switch off for at least 2 minutes, to recover.
11 Don't use accessories or attachments other than those we supply.
12 Don't use the appliance for any purpose other than those described in these instructions.
13 Don't use the appliance if it's damaged or malfunctions.
14 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
C PREPARATION
1 Sit the motor unit on a dry, firm, level surface, near a power socket.
2 Route the cable so it doesn't overhang, and can't be tripped over or caught.
C FIT THE DRIVE SHAFT
3 Push the drive shaft up through the bottom of the jug.
4 Use the tabs to turn it clockwise and lock it to the bottom of the jug.
, If you need to rinse the jug, turn the tabs anti-clockwise, and remove the drive shaft first, to
avoid getting it wet.
C FIT THE JUG
5 Sit the jug on the motor unit, with the handle to the right of the controls.
6 Turn the jug clockwise to bring the handle between the controls.
C FIT THE ACCESSORY
7 To process, fit the chopper over the pillar in the centre of the jug.
8 To grate or slice:
a) Fit the disc support inside the pillar, over the drive shaft.
b) Lower the disc on to the disc support.
c) To slice, the slicing blade must be on top of the disc.
d) To grate, the slicing blade must be on the bottom of the disc.
C FIT THE LID
9 Hold the lid over the jug, with the safety switch to the right of the handle.
10 Lower the lid on to the jug.
11 Turn the lid clockwise to bring the safety switch into the gap at the top of the handle.
12 The controls will only operate with the lid and jug in this position.
household use only
66