Publicité
Les langues disponibles
Les langues disponibles
Prepare your camera for use
Lithium battery installation
First install the lithium battery supplied with the camera according to the following instructions so that it can operate.
1.
Slide the battery cover below the camera to open the battery compartment:
2.
Insert the lithium battery in the correct polarity direction.
3.
Then close the battery cover and slide it to lock it in place.
4.
Once the camera is on, a battery icon will show up at the bottom right of the LCD screen.
Note:
A "low battery" warning will show up on the screen when the battery charge is insufficient. Shortly thereafter your camera
-
will power off.
- Please remove the battery if you are not going to use the camera for a while in order to extend its life time.
Lithium battery charging
To recharge the lithium battery, simply connect the camera (without removing the battery) to your computer using the USB
cable provided in the box. The red LED on the back of the camera will light up to indicate that the battery is being charged, and
will turn off when fully charged. You can also charge the lithium battery by connecting the camera to AC power if you have an
adapter to which you can connect the USB cable.
SD memory card installation
This camera supports SD memory card up to 32 GB. It is necessary to insert a SD card into the camera before using it to extend
its storage capacity. To remove the card, simply press it firmly and the card will eject itself from the slot.
Full battery power
Medium battery power
Low battery power
Publicité
