Publicité
BINDING
Linking the transmitter identification code to
the receiver (binding)
NOW YOU CAN SET OFF ON YOUR TRAVELS
1
Avoid continuous running. Allow the motor to cool down approxi-
mately 30 minutes after running.
CAUTIONS WHEN OPERATING THE RC MODEL
3
If the vehicle stops responding to the transmitter, switch the trans-
mitter and vehicle off and then back on again.
The transmitter and vehicle will link up with each other again.
2
Never run the model on public roads or streets, as it could
endanger traffic.
• Never run the model in crowded areas, near or toward people or
animals, to prevent property damage and/or personal injury.
• Never run the model on grassland. Twining grass may hinder
axle rotation and may cause motor heat buildup.
• Never run the model near rivers, ponds or lakes as to prevent RC
model from dropping into the water.
• Never drive the model outdoors in rain or snow-fall. Operate
the vehicle only on dry ground (puddles and snow must be
avoided).
17 // GB
Publicité
