Instructions For Use: Pilot-24 Plus; Charging The Battery - Medistrom Pilot-12 Plus Guide D'utilisation

5. DC OUT: This port is used to connect a PAP device to the battery.
First, select the proper output cable for the PAP device being used.
Select Output Cable (B) for ResMed S9™, or Output Cable (C) for
ResMed AirSense™ 10. Attach one end of the output cable to the
PAP device and plug the other end into the "DC OUT" port on the
battery.
6. LED Flashlight: LED Flashlight provides light.
7. LED Flashlight Control Button: This button is used to turn the LED
Flashlight on and off. Press the LED flashlight control button once to
turn the flashlight on. Press it again to turn the flashlight off.
8. PROTECTIVE ALARM: Alarm will sound and yellow LED will flash
when the remaining power of the battery is less than 5% or in case
of battery failure. When alarm sounds, press the Mute button once
to mute the sound. Yellow LED light stops flashing only after battery
is charged or battery is turned off. Please note: if alarm sounds while
battery is charging, please remove the charger from battery, and
sound alarm will stop.

1.5 INSTRUCTIONS FOR USE: Pilot-24 Plus

A. Charging the battery
Charging the battery with ResMed AirSense™ 10 Original Power
Adapter
(Please Note: ResMed AirSense™ 10 Original Power Adapter is NOT
included with Pilot-24 Plus. It is provided with the ResMed
AirSense™ 10 PAP Device). Plug the ResMed AirSense™ 10 Original
Power Adapter into the battery's CHARGE port. Ensure that the
8