the OFF position before storing the battery. CAUTION: FULLY
CHARGE BATTERY BEFORE STORAGE AND EVERY 6 MONTHS!
3. CHARGE LEVEL INDICATOR: By pressing the charge level indicator
button (3a) the charge level of the battery can be checked. The
green LED (3c) will light up for 4 seconds showing the battery charge
level, while battery is powering your PAP device. If 4 charge
indicator lights (3c) are lit green, then the battery is fully charged.
Please refer to the LO to HI charge level indicator image (3d) to
determine the remaining power level. When the battery is charging,
the charge indicator LEDs (3c) will light up in sequence the charge
reaches each level. When the battery is plugged into the charger,
but is already fully charged, then all charge indicator lights are lit
solid green. Warning Indication: Once CPAP battery is fully
discharged, the orange warning light (3b) will flash, and the sound
alarm will beep. Discontinue using your PAP device and charge the
battery as soon as possible.
4. USB PORT: This port can be used to power and charge most
electronic hand-held devices.
5. DC OUT: This port is used to connect a PAP device to the battery.
First, select the proper output cable for the PAP device being used.
Select Output Cable (B) for ResMed S9™, or Output Cable (C) for
ResMed AirSense™ 10. Attach one end of the output cable to the
PAP device and plug the other end into the "DC OUT" port on the
battery.
6. LED Flashlight: LED Flashlight provides light.
7. LED Flashlight Control Button: This button is used to turn the LED
Flashlight on and off. Press the LED flashlight control button once to
turn the flashlight on. Press it again to turn the flashlight off.
8. PROTECTIVE ALARM: Alarm will sound and yellow light will flash
when the remaining power of the battery is less than 5% or in case
of battery failure. When alarm sounds, press the Mute button once
to mute the sound. Yellow LED light stops flashing only after
battery is charged or battery is turned off. Please note: if alarm
15