EQUATION DL06 STAND Notice De Montage - Utilisation - Entretien page 46

FR
3. HOW TO USE
ES
OPERATION OF THE HEATER
NOTE : It is normal when the heaters are turned on for the rst time or when they are
PT
turned on after having not been used for long period of time the heaters may emit some
IT
smell and fumes. This will disappeare when the heater has been on a short while.
Choose a suitable location for the heater, taking inot account the safety instruction above.
EL
Insert the plug of the heater into a suitable socket.
PL
UA
Turn THERMOSTAT KNOB fully in a clockwise direction to the maximum setting.
Turn on the heating elements by means of HEATER SWITCHES on the side panel. When the
RO
heating elements are on the switches will illuminate. For maximum heat output both
EN
switches should be on. When the desired room temperature has been reached, the
thermostat knob should be turned slowly anti-clockwise until the thermostat is heard to
click o and the lights on the element switches are seen to go out. After this the heater
will keep the air temperature in the room at the set level by switching ou and o
automatically.
PROTECTION AGAINST OVERHEATING
An additional tted safety thermostat protects the heater against overheating and
switches it o automatically. The service lamp then goes out. The heater is ready for
service again after a short cooling-o phase (approx. 15 minutes).
If this repeat itself, rst check whether the thermostat switch it set correctly or if objects
hinder the heating operation.
4. CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and bu with a dry cloth. Do
not use any detergents or abrasives and do not allow any water to enter the heater.
5. STORING THE HEATER
When the heater is not used for long periods of time, it should be protected from dust and
stored in a clean dry place.
46