Publicité
Les langues disponibles
Les langues disponibles
2610048691.qxp_RH328VC 10/4/17 9:09 AM Page 10
AUXILIARY HANDLE
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen
the hand grip, move the handle to the
desired position along the barrel and
securely retighten the hand grip (Fig. 9).
DEPTH GAUGE
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
HAND GRIP
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
FORWARD/REVERSE SWITCH
The reversing switch is used to reverse rotation
of the bit (Fig. 1).
when the motor is "OFF" and when bit is at a
complete standstill.
Drilling only:
used for drilling
wood, steel, etc.
Operating Instructions
The reversing switch
should only be activated
Drilling/hammering:
used for drilling
concrete
Setting depth: After the auxiliary handle is
installed, make sure the accessory has been
fully inserted into the tool holder before
setting the depth gauge (Fig. 10).
To adjust depth, push the depth gauge
release button, slide the depth gauge to
desired depth and release pressure on
button to lock the depth gauge in place.
FIG. 10
DEPTH GAUGE
RELEASE BUTTON
DEPTH GAUGE
To use tool in "Forward" rotation move switch
torward the arrow
"Reverse" the rotation of the bit move the
switch torward arrow
SELECTOR DIAL
The selector dial allows the tool to be set for
various drilling/hammer drilling and chipping
applications.
Depress release button and
turn selector dial right or left depending on
the below applications (Fig. 11).
When using demolition or chipping bits such as
bull points, chisels, spades, gouges, etc. the
"Hammer Only" mode must be selected.
tool comes to a complete stop. Shifting during
rotation of the chuck can cause damage to the
tool.
Vario-lock
allows for 12 desired
positions of "hammer"
FIG. 11
-10-
X
that depicts forward.
that depicts reverse.
Do not operate the
selection dial until the
Hammering only:
used for light
chipping work
Publicité
