Valor 1130CIK Directives D'installation page 5

7. Set aside the side doors, removable panel and bar-
rier screen to install later when the appliance's set-
up and wall fi nish application are completed.
8. Continue the installation of the appliance as indi-
cated in the H5 Installation Manual.
Finish kit installation
Once the appliance installation and wall fi nish is
completed, fi nish the installation of the framing kit.
1. Slide the removable panel at the bottom of the
fi replace into the clips on the horizontal supports on
each side; the panel covers the valve and goes
under the fi rebox. Push the panel in until fully
inserted into the clips.
2. Identify left hand door from right using diagram
below.
Left Side Door
Tab at the bottom
Right Side Door
3. Position LH door to left side of front frame, identify
top and bottom door slots just behind front panel
and slide door locator laterally into slots. Then slide
door down.
4. Repeat for other
door.
5. Install the barrier screen. The tabs rest at the bot-
tom, and the screen is held in place by magnets.
a. Rest the bottom tabs on the edge of the
removable panel as indicated.
b. Push the screen against the steel front panel.
a
tabs at the
bottom
IMPORTANT
The barrier screen should sit as low as possible, to
leave an air gap at the top. This is intentional for
proper air flow.
WARNING
For safety purpose, ensure the barrier
screen is re-installed onto the fi replace
after maintenance.
b
a
5