Valor 1130CIK Directives D'installation page 4

3. On the appliance, install the side panels as indicated
(3 x 1/2" screws per side).
4. Install the upper fi nishing strip in the
orientation shown at right, under the
appliance's case top edge:
With no HeatShift. Remove the 3 screws retaining a
removable convection baffl e and slide the fi nishing
strip over the baffl e`s tabs, then secure the strip
and baffl e together using 3 countersunk screws
supplied.
ONLY with HeatShift. Remove the 3 screws retain-
ing the removable convection baffl e, remove the
baffl e, then slide the fi nishing strip over the screw
holes and secure it with 3 countersunk screws
supplied. Discard the convection baffl e.
NOTE
Use of the optional HeatShift System requires
the convection baffle to be removed above the
firebox. See Appliance Preparation, Optional
HeatShift or HeatShift section in Appendix D of
the appliance's installation manual.
4
Ensure there is no
gap between the
upper fi nishing strip
and the side panels.
If there is a gap,
release the side
panel's 3 screws,
push the panel up to
close the gap and
tighten the screws.
5. Install the top panel as indicated (3 x 1/2" screws).
Curves upwards
in fireplace
Bottom
Side View
6. Ensure the appliance is snug against the framing
and secure it to the studs on each side (5 fi xing
points per side). Use wood screws (not supplied with
this kit).
Upper
finishing strip
Side
panel