Cleaning The Trimmer - Panasonic ER-GK60 Mode D'emploi

Cleaning the trimmer

• Clean the trimmer and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the trimmer is turned off.
• Remove the trimmer from the AC adaptor.
►With water
Main body, blade and the attachment
To remove light dirt
1. Remove the attachment and
turn the trimmer on.
2. Run water down the water
inlet at the back of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the trimmer
off.
• Rinse with water and shake
up and down several times
to remove the water.
• Be careful not to hit the main body on the sink or any other
object while draining the water. Failure to do so may cause
malfunction.
PB014575 - ER-GK60 01EN_03-29-17.indd 13
To remove heavy dirt
1. Remove the attachment and
blade.
2. Clean the trimmer, the blade
and the attachments with
running water.
• Rinse with water and shake
up and down several times
to remove the water.
3. Wipe off the water with a towel and
let it dry naturally.
• It will dry faster with the blade
removed.
4. Apply the oil to the blade after drying.
(See page 14.)
5. Attach the attachment and the blade
to the main body.
►With the brush
Main body and blade
• Remove the blade. (See page 14.)
1. Brush off any hair trimmings from the
main body and from around the blade.
2. Brush off the hairs from the blade edge.
3. Brush any hair trimmings out from between
the stationary blade and the moving
blade while pressing down the cleaning
lever ( ) to raise the moving blade.
b
4. Apply the oil to the blade. (See page 14.)
5. Attach the attachment and the blade to the main body.
b
13
2017/3/29 10:09:10