Troubleshooting - Panasonic ER-GK60 Mode D'emploi

Lubrication
• Apply the oil to the blade before and after each use.
1
Remove the blade.
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the main
body, turn on the power and
allow to run for
approximately 5 seconds.
►Replacement part
Replacement part is available at your dealer or Service Center
Replacement part for ER‑GK60
Removing and mounting the blade
Removing the blade
Hold the trimmer and push the blade
with your thumb.
Mounting the blade
Fit the mounting hook ( ) into the blade mounting (
B
trimmer and then push in until you hear a click.
A
B
14
PB014575 - ER-GK60 01EN_03-29-17.indd 14
Blade WER9500
) on the
A

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the store where you
purchased the unit or a service center authorized by Panasonic
for repair.
Problem
Apply oil. (See this page.)
Makes a loud sound.
Confirm that the blade is properly
attached.
Until problems are solved, please
follow each procedure as follows;
1. Charge the trimmer.
(See page 9.)
2. Clean the blade and apply oil.
(See pages 13 and 14.)
The trimmer has
3. Replace the blade.
become blunt.
(See this page.)
4. Contact the store where purchased.
Trimmer stopped
Charge the battery for approximately
functioning.
30 hours continuously to rejuvenate it.
If few uses remain even after
Operating time is short.
charging, the battery has reached the
end of its life. (Fluid may be leaking
due to degradation at the end of
battery life.)
Contact an authorized service center
for repair.
Mount the main body firmly on the
The trimmer cannot be
charging plug, and make sure the
charged.
charge indicator lamp glows.
Action
2017/3/29 10:09:11