Telecom Behnke 20-0040-IP Mode D'emploi page 30

Additional SIP door bell / SIP PA system connection
GB GB
Introduction
▸
The 20-0040A-IP electronics are pre-assem-
bled and contain DIP switches for loud-
speaker switching / loudspeaker power-off in
PA system mode in the housing. The housing
must be opened for this.
30
Mode: In transport mode in Pos. "Z"
Function of additional door bell/SIP PA
(do not switch)
LS: In transport mode, the loudspeaker in
the ,, additional door bell /SIP PA system is
active.
Pos. "O" loudspeaker in the additional door
bell/SIP PA system is inactive.
To reconfigure the loudspeaker function,
open the additional door bell/SIP PA system
connection. To do so, loosen the 6 screws
on the bottom/base and carefully open the
bottom of the door intercom station.
Caution: Attachment parts of the additional
door bell/SIP PA system are connected to the
board on the bottom of the housing by means
of connection cables!
www.behnke-online.com